Browse documentation

Output & result settings

Choose how the result is created, simplify redundant loops, transfer existing UV maps, and reuse the settings saved on a result.

On this page

Choose the source and output

Use evaluated mesh
Includes the source's evaluated modifier result. Disable it to use the base mesh. Source modifiers are not copied to the new object.
New object
Creates a remeshed object and keeps the source visible.
New object + hide source
Creates a remeshed object and hides the source in the current view layer after success. The source is kept, so you can show it again to revise guides, paint, or edge rules.

Keep a first result as a baseline. Select the original source again before drawing more guides or changing paint maps for another pass.

Set the shading

Smooth result applies smooth shading to the new mesh.

Mark detected hard edges marks preserved, angle-detected edges as Blender sharp edges on the result. It requires Auto by angle. Drawn guides and symmetry seams are not marked by this option.

To control which paths the remesh preserves, use Edge Rules. Sharp marking controls result shading.

Remove redundant loops

Enable Post Optimize for an optional simplification pass after remeshing. It removes redundant loops while preserving quad faces and the surface within the chosen tolerance.

Surface tolerance is the permitted surface change as a percentage of result size. Higher values allow more simplification. Start low, compare the silhouette and small features with the source, and increase it only if the result remains suitable.

Check the intended use.

Post Optimize is intended for static hard-surface meshes. It can make longer quads, reduce the final count below the target, and change deformation or subdivision behavior. Inspect those uses separately before accepting the result.

Target count adjustment runs before this pass. Disable Post Optimize when comparing how closely the remesher meets your target.

Transfer Source UVs Experimental

  1. Check the source UVs.

    The source needs existing UV maps. With Use evaluated mesh enabled, the evaluated source supplies them.

  2. Enable Transfer Source UVs.

    WQuads projects the existing source maps onto the final result, accounting for UV island boundaries.

  3. Remesh and inspect.

    Check the run summary and view the result's UV maps and textures, especially around seams and small islands.

Coarse output faces can distort textures near seams. Try a denser result or revise the UVs if those areas matter. This option transfers existing maps; it does not create an unwrap for a source without UVs.

If the source has no UV maps, the summary reports No source UV maps. A transfer failure is reported separately; inspect the result and export a support report if needed.

Inspect and reuse Result Settings

  1. Select a WQuads result.

    Result Settings appears when the selected object has saved run data.

  2. Review the saved choices.

    The panel shows the target, layout, curvature, symmetry, and edge detection choices. Expand More settings for remesh, edge, symmetry, paint, guide, and output settings, plus the source name and marked-edge counts.

  3. Click Use These Settings.

    This restores the compatible saved values into the current WQuads controls. Select the original source before running another remesh.

Maps and guides belong to the source.

Use These Settings restores parameter values. Painted maps, drawn guides, and edge marks stay on their source object and are not copied by this action. Keep that object when you want to reproduce a guided or painted run.